Monterey M3 Owner's Manual page 94

Exterior Equipment
Lay Down Sun Lounge - Extended
There is a cooler below the port lounge seat cush-
ion that drains to the cockpit and there are drink
holders located on each end of the lounge. The
cooler is accessed by lifting the front of the cushion
slightly, then pulling it forward and clear of the
backrest so it can be raised to the full up position.
On M5 models, there is another cushion forward
of the cooler with a storage compartment below
the seat. There is also a fold down armrest with
drink holders.
The sun lounge seat is equipped with an electric
actuator that extends the seat and converts the
lounge from a back to back bench seat to a sun
lounge. The aft seat actuator is controlled by the
Aft Seat switch in the panel next to the stereo.
To convert the seat to a sun lounge, press and
hold Extend until the seat is fully extended and
all cushions are flat. To return the lounge to a
back to back bench seat, make sure the lounge
backrest cushion is in the full down position, then
press and hold Retract until the seat is in the full
up position.
Notice:
The seat must be in the fully retracted posi-
tion before the engine hatch can be raised.
The hinged rear cushion of the lounge seat has
four positions controlled by a sliding support lo-
cated below the cushion that is visible when the
seat is fully extended. When the support is in the
full aft position, the cushion is flat and makes a full
lay down sun lounge. This is the default position
when the seat is first extended and the cushion
must be in this position before the lounge seat can
be retracted to the upright position. The three
notched positions in the support track allow the
cushion to be converted to a backrest and set at
Sun Lounge with Backrest Up
Sliding, Adjustable Support for Sun Lounge Backrest
different angles whenever the lounge is fully ex-
tended. The backrest is raised by lifting the rear
of the cushion and sliding the support forward to
the desired position. When the support reaches
the desired position, allow it to drop slightly into
the notch in the track to lock the back rest. To
change the backrest position, lift the rear of the
cushion until the support lifts out of the notch and
slide it to the new position. Make sure to support
the weight of the cushion with one hand while
positioning the support to prevent the cushion
from accidently dropping and pinching your hand
or fingers.
MONTEREY
BOATS
95