Recommissioning - Monterey M3 Owner's Manual

Seasonal Maintenance

14.3 Recommissioning

WARNING
DO NOT OPERATE THE BOAT UNLESS IT IS COMPLETELY
ASSEMBLED. KEEP ALL FASTENERS TIGHT. KEEP ADJUSTMENTS
ACCORDING TO SPECIFICATIONS.
NOTICE:
It is important and recommended that the
fitting out procedure for the marine gear be
done by a qualified marine technician. Read
the engine owner's manual for the recom-
mended procedure.
Reactivating The Boat After Storage:
• If your boat is bottom painted, apply a fresh
coat of bottom paint on the hull and outdrive
• Inspect outdrive and thru-hull fittings.
• Install the propellers. Refer to the outdrive
owner's manual for information on installing
propellers.
• Install the drain plug in the hull.
• Charge and install the batteries.
• Check the engine for damage and follow the
manufacturer's instructions for recommission-
ing.
• Check the engine mounting bolts to make sure
they are tight.
• Perform all routine maintenance.
• Check all hose clamps for tightness.
• Pump the antifreeze from the fresh water sys-
tem and flush several times with fresh water.
• Check and lubricate the steering system.
• Clean and wash the boat.
• Install all upholstery, cushions and canvas.
• Check the fluid levels in the engine and out-
drive.
After Launching:
• Carefully check the engine and all water sys-
tems for leaks. Operate each system one at
a time checking for leaks and proper opera-
tion.
• Check the bilge pump automatic and manual
switch.
• Prime the fuel system and start the engine.
• Carefully monitor the gauges and check for
leakage and abnormal noises.
temperature gauge closely until it stabilizes at
normal operating temperature to ensure that
the cooling pump is operating properly.
• Operate the boat at slow speeds until the en-
gine temperature stabilizes and all systems
are operating normally.
MONTEREY
BOATS
Monitor the
127