Wet Sounds Audio System (Optional M5 And M3) - Monterey M3 Owner's Manual

Electrical System
6.3 Wet Sounds Audio System
(Optional M5 and M3)
The Wet Sounds Audio System is included with
the MSX package on the M3 and M5. The audio
system consists of:
(1) Wet Sounds SYN4 amplifier (controls the tower
speakers)
(1) Wet Sounds SYN6 amplifier (controls the boat
speakers and subwoofer)
(4) WS65 6.5" Full range in-boat speakers
(1) 10" dual voice coil subwoofer
(2) MB8 tower speakers
(2) Pro60 tower speakers
(1) WS420 Parametric Equalizer with microphone
The amplifiers have been preset for best per-
formance at the factory. These settings were
obtained using the "Rock" EQ setting on the MB
Quart head unit. Make sure the EQ setting on the
MB Quart head unit has not been changed. The
optimum settings have been included in this guide
66
Wet Sounds Equalizer Control Panel
for your reference should you ever need to return
the amplifiers to their original settings.
Normal Operation:
Each knob on the equalizer has an inner knob and
an outer ring that can be adjusted (except for the
microphone volume). The inner knob controls that
setting for the boat speaker and the outer ring
controls that setting for the tower speakers. For
normal operation, all audio knobs on the equalizer
should be set to zero (indicator lines at 12 o'clock
position). When first starting your audio system,
turn the volume knob to the 12 o'clock position
and the outer ring all the way to left (tower speak-
ers off). This is the normal listening position. Use
the volume control on your MB Quart head unit or
one of the remote controls to adjust the volume to
your desired listening level. Do not exceed 30 on
the MB Quart volume level to avoid excess distor-
tion. If this level is exceeded, the subwoofer may
clip. This will temporarily shut the boat amplifier
down and a fault flash will occur on the amplifier
MONTEREY
BOATS