Menu Network; Lan Parameter; Account; Cloud Notific - AMC KX Series Installer Manual

menu network

lan parameter

With this parameter it is possible to set IP address for IP Board:
First enable IP board from peripheric menu.
select DHCP to 1 for automatic setting, wait few minutes after exit from menu. In case doesn't work:
- set 0 and set static IP and other parameter of network
iP address: eg. 192.168.000.008
subnet mask: 255.255.255.000
Gateway: 192.168.001.001
Dns1: 008.008.008.008
Dns2: 208.067.000.000
For complete all parameter it is important to know the network parameters where the IP is connected.
Set the free static address for ip board, complete all parameters.
Exit from menu and wait few minutes. When the IP is connected must be see:
green led = steady (IP enable on peripheric)
orange led = blink machine running (when the led is steady or in OFF the machine nor run)
1° red led = off cloud connected (turn ON disconnected)
2° red led = off internet connected (turn ON disconnected)
little red = lan speed (OFF=10 ON = 100MB)
nOte: when the system is in DHCP is important to know that the router assign iP to the machine (in some case is
necessary wait few minutes, or set the roueter to do this).
cloud parameters
DOn't mODiFY tHis FielD this is the cloud address

account

I this menu are all parameter that used for registartion to the cloud. ( for APP)
enable Cloud service: this parameter is important, because is the activation of 30'' ping on Cloud, for maintain the system
always connected to the Cloud. the transmission on Cloud is in ssl4 cripted
username:it used for name ID, the same name must be inserted to the APP during to the registration panel
password: password, the same password must be inserted to the APP during to the registration panel
uiD CODe: this code is most important because is the unique identification code of panel. Must be inserted to the APP with all
number and characters iDentiCal.
nOte:it is possible have the same password and username with different uiD in the same aPP (main house, beach
house etc.)

Cloud notifiC.

With this parameter it is possible to enable and disable smart notification in phone APP when it closed.
alarm: when the system trig in alarm it is possible receive notification on smartphone (even when the application is closed)
users: when is enabled every action by all user are sent by notification APP (even when the application is closed)
arminG:When is enabled every arm and disarm for each program are sent by notification (even when the application is closed)
For enable notification turn from 0 to 1 every single voice:
eg. alarm = 1 (enaBleD) alarm=0 (DisaBleD)
GPRS PaRameteR
In this section there are all parameters for enable the GPRS system for cloud APP and for sending CMS messagges:
enable GPrs: this parameter enable the module GPRS to work, when is disabled the system work only in GSM mode.
access point aPn: set the name of access point
user name aPn: some provider needs the name and password, in this section set the name
user password aPn: some provider needs the name and password, in this section set the password
www.amcelettronica.com
74
KX series v.1.70