System Events Menu; Link Phone Num. - AMC KX Series Installer Manual

SyStem eventS menu

Link Phone num.

The events list that can be associated to telephone numbers (s = sms V = voice t = sms-voice - = not associated)
- Go to the link phone num. menu
- Press ENTER and use the vertical arrows to scroll through the available events marked with M (see list above)
- Press ENTER when the cursor flashes, use the right or left arrow key to move to the desired telephone numbers.
- Use the S button to assign the sms to the telephone numbers.
- Confirm with ENTER
s = OnlY sms V = OnlY VOiCe t = sms+VOiCe - = nO assOCiatiOn (CanC KeY)
M01/Tel
* - Play
nOte: by pressing left arrow or * it is possible to see the description of m event
Select the desired events from the assignment menu:
m1 = no main power
- now general power to the system, you can delay the SMS and voice notification from 0 to 240 min
m2 = main power return
- immediate return of the general system power supply
m3 = low battery
- backup battery in the control unit is low, notification after 1 min. (below 10.5Vcc low, above 11.5Vcc charged)
m4 = life test
- Period lift sign test, can be set from 1 to 240 hours
m5 = no gsm network
- notification of no GSM network/signal, immediate.
m6 = tampering
- opening of the control unit, tamper line tampering, serial line tampering, balance line sensor tampering (Note: you can check the
details of each tampering in the event log)
m7 = radio disturbance
- Notification of radio signals issued by other equipment on the same frequency range. It does not compromise operation.
m8 = radio saturation
- Radio signals issued from other equipment that compromise the safety of the system, radio blinding alarm. The system is no longer
communicating with the radio peripherals.
m9 = radio battery KO
- Notification of low battery in a saved radio device (remote controls, sensors, contact, etc.). You can consult the event log for details
regarding the device.
m10 = no supervision
- Notification of lack of supervision by the programmed radio devices. This notification is activated when the system does not receive
8 consecutive transmissions.
m11 =tamper disp.radio
- Notification of tampering with/opening of programmed radio devices
m12 = user access not enabled
- Notification of attempted access by a user with a timer blocked code. This is activated when the code is not enabled in a pro-
grammed time frame.
m13 = block from incorrect codes
- Notification of system block due to repeated access attempts by invalid user codes or codes not enabled by the timer. The event is
activated after 5 attempts (The system remains locked for 10 minutes). Each reset attempt or other manoeuvre, including general
shutdown of the system, resets the counter which starts the count over from the top.
m14 = anti-aggression panic
- Notification of anti-aggression panic event. It is generated by a user code programmed for anti-coercion. This code works like a
normal user except it activates and emergency coercion call to the programmed numbers.
m15 = Pstn KO
- Notification of PSTN line fail event
m16 = Pstn OK
- Notification of PSTN line restore event
m17 = fault connection
www.amcelettronica.com
12345678
* button pressed
VS-T--------
fault 230V
* - Play
41
KX series v.1.70