Mercedes-Benz CL2012 Operator's Manual page 90

Table of Contents

Advertisement

Side windows
88
Using KEYLESS-GO
The KEYLESS-GO key must be outside the
vehicle. All the doors must be closed.
X
Touch recessed sensor surface : on the
door handle until the side windows and the
sliding sunroof are fully closed.
i
Make sure you only touch recessed
sensor surface :.
X
Make sure that all the side windows and the
sliding sunroof are closed.
X
To interrupt convenience closing:
release recessed sensor surface : on the
door handle.
Resetting the side windows
You must reset each side window if:
a front side window cannot be closed
R
automatically
a side window opens again slightly after
R
being closed manually
X
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Pull the corresponding switch on the door
control panel until the side window is
completely closed. (
X
Hold the switch for an additional second.
Y
page 86)
I n f o r m a t i o n P r o v i d e d b y :
If the side window opens again slightly:
X
Immediately pull the corresponding switch
on the door control panel until the side
window is completely closed (
X
Hold the switch for an additional second.
X
If the corresponding side window remains
closed after the button has been released,
the side window has been reset correctly.
If this is not the case, repeat the steps
above again.
Problems with the side windows
Problem: a side window cannot be closed
because it is blocked by objects, e.g.
leaves in the window guide.
X
Remove the objects.
X
Close the side window.
Problem: a side window cannot be closed
and you cannot see the cause.
G
WARNING
Closing the side windows with increased force
or without the anti-entrapment feature could
lead to serious or even fatal injury. Make sure
that nobody can become trapped when
closing the side windows.
If a side window is obstructed during closing
and reopens again slightly:
X
Immediately after the window blocks, pull
the corresponding switch again until the
side window has closed.
The side window is closed with increased
force.
If a side window is obstructed again during
closing and reopens again slightly:
X
Immediately after the window blocks, pull
the corresponding switch again until the
side window has closed.
The side window is closed without the anti-
entrapment feature.
Y
page 86).

Advertisement

Table of Contents
loading

Table of Contents