Mercedes-Benz CL2012 Operator's Manual page 167

will appear asking whether you wish to
overwrite the existing data.
X
Yes No
Select or and press W to confirm.
If you select Yes, COMAND stores the data.
Deleting a destination or the home
address from the destination memory
X
To activate navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Destination
Select
system menu bar by turning cVd the
COMAND controller and press W to
confirm.
X
From Memory
Select
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
X
Option 1: destination memory list with
character bar: proceed as described in the
"Entering characters using the character
bar" section ( Y page 119).
X
Option 2: destination memory list as
selection list: select a destination by
turning cVd the COMAND controller and
press W to confirm.
You see the address data of the selected
entry.
X
Delete
Select and press W to confirm.
A prompt appears asking whether you wish
to delete the destination.
X
Yes No
Select or and press W to confirm.
If you select Yes, COMAND deletes the
destination. You will see a message to this
effect.
If you select No, the process is aborted.
i If the navigable address data for the
destination being deleted is also assigned
to an address book entry, COMAND will
also delete this data from there. If the
in the navigation
and press W to
I n f o r m a t i o n P r o v i d e d b y :
corresponding address book entry does
not contain any further data, such as
telephone numbers, COMAND deletes the
entire address book entry.
Previous destinations
Introduction
COMAND automatically stores the previous
destinations for which the route calculation
has been started. If the memory is full,
COMAND deletes the oldest destination. You
can also save a destination from the list of
previous destinations in the destination
memory. It will be stored there permanently.
Storing a destination permanently in
the destination memory
X
Proceed as described in the "From the list
of previous destinations" section
( Y page 163).
Storing the vehicle position in the list of
previous destinations
X
To activate navigation mode: press the
S function button once or twice.
X
To show the menu: press W the COMAND
controller.
X
Position
Select in the navigation system
menu bar by turning cVd the COMAND
controller and press W to confirm.
X
Store Vehicle Position
Select
press W to confirm.
COMAND stores the current vehicle
position as a destination in the list of
previous destinations.
Navigation
165
and
Z