Functioning Mode; Programming - ergoline Vertical series User Manual

FUNCTIONING MODE

PROGRAMMING

The purpose of this chapter is to describe how the system works, giving a detailed description of
several pages on the display and of several steps during a treatment; it's also possible to setup some
features of the unit.
The electronic control device mainly carries out the function of a timer: it enables a tanning treatment
of programmed duration to be carried, automatically providing for the switching on and off of the
lamps and the cooling fans of the cabin and the tanning system.
Implemented in the electronic device are also meters in which the equipment activity times are
memorized and that can be used for controlling takings.
The first page you can see shows as the following:
1 E R G O L I N E
S T A R T
This page will come back automatically if you do not press any button for 3 minutes (of course not
during the treatment!); pressing one of the 4 buttons you can enter in the following page:
2 T R E A T
The treatment duration shown on the display is the last one you have entered in the service menu;
Pressing START button the page below will be shown, and you can listen the following vocal message:
Welcome, we hope you enjoy your pleasant moment of relaxation while you tan. Please make sure
"
you removed all make up, and contact lenses and you're wearing protective goggles. To control the
ventilation, use the dial on the lower right of the panel
2a L E F T T I M E
Then the treatment begins and the following page appears:
2b L E F T T I M E
At half time of the session you'll listen the following vocal message:
You're now halfway through your sunbed session
"
When 10 seconds to the end are missing, you can hear the following vocal message:
Your session is now ending. Thank you and goodbye
"
D U R 1 0 : 0 0
S T A R T E S C
1 0 : 0 0
S T O P
0 9 : 4 8
S T O P
Seite 19 von 29
Press ESC for going back to page 1
".
Vocal message running
Decreasing time is shown
".
".
Ergoline Vertical
User manual