Table of Contents
Advertisement
Front View
Figure 2-16 shows the location of the front system controls and indicators on a
system that includes the hot-swap SCSI disk drive bays.
A.
Eject button, 3 ½-inch diskette drive
B.
Activity light, 3 ½-inch diskette drive
C.
Activity light, CD-ROM reader
D.
Load/eject button, CD-ROM reader
E.
Drive Present LED
F.
Drive Activity LED
G.
Drive Status LED
H.
DC power ON/OFF Button
I.
DC Power ON/OFF LED
J.
Intrusion Indicator LED
K.
Disk Fault LED
L.
Sleep Status LED
M.
Sleep Button
*Disk array configuration only.
Figure 2-16. Front System Features and Controls (Hot-Swap Bays)
2-20 Setting Up the System
A
B
D
C
E
F
I J
H
Press to eject diskette.
When lit, diskette is in use.
When lit, CD-ROM reader is in use.
Press to load CD and eject CD.
When green, drive is present. See Table 2-2.
When green, Drive is active. See Table 2-2.
*Indicates drive failure. See Table 2-2.
Press to turn system DC power on or off.
When green, power is present in system. When
off, power is turned off, power source is
disrupted, or system is in the sleep mode. See
Table 2-1 for a list and description of the system
LEDs.
When OFF, the system is OK. See Table 2-1 for
a list and description of the system LEDs.
When lit, a disk drive fault occurred. See Table
2-1 for a list and description of the system LEDs.
When lit, system is in Sleep Mode. See Table
2-1 for a list and description of the system LEDs.
Press to enter power saving (sleep) mode. Press
again to enter normal mode of operation. This
function requires a corresponding operating
system.
G
K L M
Advertisement
Table of Contents
Troubleshooting
