Clearing And Changing The Passwords - NEC EXPRESS5800/120Le User Manual

Clearing and Changing the Passwords

To clear and change the passwords:
1. Power off the system and remove the left side panel as described in
Chapter 4 of this guide.
2. Check to ensure the system power cord is removed from the back of the
system.
3. Remove the spare jumper from position 11 - 12 on jumper block.
4. Reinstall the spare jumper on position 3 - 4 (Password Disable) of the
jumper block. Refer to Figure 3-1 and Table 3-3 to find the location of this
jumper.
5. Connect the power cord, power on the system and while waiting for POST
to complete, press the F2 key to enter BIOS setup. This automatically clears
all passwords, provided you exit and save the BIOS setup.
6. Power off the system and remove the power cord.
7. Remove the Password Disable jumper from pins 3-4 and store it in position
11 - 12.
8. Replace the left side panel, connect the power cord and power on the
system.
9. To specify a new password run the BIOS Setup Utility as described earlier
in this chapter.
3-22 Configuring Your System