NEC EXPRESS5800/120Le User Manual page 17

Your server includes hot-swap SCSI hard disk drive bays. See Figure 1-3. The hot-swap
SCSI hard disk drive bays support a maximum of six 1.0-inch SCSI hard disk drives
that can be swapped in or out of the system without powering down, if a RAID
controller is configured in the system.
Figure 1-3. SCSI Hard Disk Drive Bays
As application requirements increase, you can expand your server with an additional
processor, additional memory, add-in boards and peripheral devices: tape devices,
CD-ROM, and hard disk drives.
Your server features the following major components:
!
Single or dual high-performance Pentium III processor.
!
64 MB to 4 GB of memory, using up to four DIMMs.
!
Six PCI expansion slots for add-in boards.
!
Embedded PC-compatible support (serial, parallel, mouse, keyboard, diskette,
USB, LAN, and video).
!
Integrated onboard ATI RAGE IIC Super Video Graphics Array (SVGA)
controller with 4 MB of video memory.
!
Adaptec AIC7899 SCSI controller providing Wide Ultra2 and Ultra-160/M SCSI
interfaces.
!
Integrated onboard Network Interface Controller (NIC), an Intel 82559 PCI LAN
controller for 10 or 100 Mbps Fast Ethernet networks with an RJ-45 Ethernet
connector.
!
Single Channel enhanced IDE controller.
!
Three 5 ¼-inch removable media expansion bays with a CD-ROM drive installed
in one bay.
!
One 3 ½-inch half-height bay with a diskette drive installed.
!
Integrated dual Universal Serial Bus (USB) ports.
!
Hardware monitors (temperature, fans, and voltage) and software monitors to
indicate failures.
0 1 2 3 4 5
System Overview 1-3