Label Locations - Carrier AquaEdge 19XR series Start-Up, Operation And Maintenance Instructions Manual

ISM MENU
Shows parameters entered on
the ISM_CONF screen on the
ICVC
DESCRIPTION
INITIAL CURRENT
MAX. CURR AS % LRA
RAMP TIME
CT RATIO
*These values are not displayed in the ISM_CONF table.
†Current Transformer Ratio
STARTER FRAME MOTOR RLA RANGE
SIZE (AMPS) (AMPS)
200 AMPS 95-135 Amps
200 AMPS 136-200 Amps
300 AMPS 201-231 Amps
300 AMPS 232-300 Amps
480 AMPS 301 -340 Amps
480 AMPS 341-480 Amps
600 AMPS 481-580 Amps
600 AMPS 581-600 Amps
740 AMPS 601-740 Amps
1250 AMPS 741-855 Amps
1250 AMPS 856-1250 Amps
CAUTION
Changing parameters may adversely affect chiller
operation.
Table 13 — Benshaw RediStart MX3 Menu Structure
CFN MENU
Initial Current as % RLA
Max. Current As% LRA
Ramp Time (seconds)
Table 14 — Benshaw RediStart MX3 Menu Items*
BENSHAW PARAMETER
CFN01
CFN02
CFN03
FUN03
CT RATIO
864:1
2640:1
2640:1
2640:1
2640:1
3900:1
3900:1
3900:1
3900:1
5760:1
5760:1
FUN MENU FL MENU
Meter #1 display Fault Log (9 faults)
Meter #2 display
CT Ratio
Time & Date Format
Time
Date
Passcode
RANGE
50-300
30-70
5-30
2640-5760
See the Initial Start-Up Checklist section for VFD Job Spe-
cific Configuration table. For job specific parameters see inside
of the VFD enclosure door. Refer to the VFD Configuration ta-
ble for the entire list of parameters.
LABEL LOCATIONS — Verify the following labels have
been installed properly and match the chiller requisition:
• Surge Parameters — Located inside the chiller control
panel.
• Chiller identification nameplate — Located on the right
side of the control panel. (See Fig. 36.)
• VFD Parameter (Unit-Mounted VFD Only) — Located
on the inside of the VFD door.
• VFD Enclosure Nameplate (Unit-Mounted VFD Only)
— Located on the right side of the VFD as viewed from
its front. (See Fig. 36.)
76
E MENU
Event Log (99 events)
UNITS DEFAULT
% 125
% 55
SEC 15
†