Operating Your Transmitter; Code Switch - NOMA 052-8398-2 Owner's Manual

Hanson led ceiling fan

Hide thumbs

Table of Contents

9. Connect the wire inside the switch housing cap by snapping

the male and female connectors together; match white wires

together and blue wire to black wire together. Screw on light

kit assembly and switch housing with 3 screws previously

removed (Fig. 9).

Installing Glass shade

. Attach the glass shade to the light kit and turn clockwise

until tight (Fig. 9).

. Now your ceiling fan is assembled and ready for use.

Restore power to the ceiling fan and test for proper operation.

10. Install the 9V battery (included). To prevent damage to transmitter,

remove the battery if not used for long periods (Fig. 10).

CODE SWITCH

CODE SWITCH: Codes are set by pushing dip switches up or down.

It is imperative that the code used for both transmitter and receiver

is exactly the same; otherwise remote

note the code switch will enable you to operate a second remote

controller independently. For example, if you have two ceiling fans with

/receiver. This will enable you to operate each ceiling fan independently.

Your remote control is ready for use after battery installation.

· Restore power to ceiling fan and test for proper operation.

· The fan remote control controls the fan setting:

HI: Turn on the fan at high speed.

MED: Turn on the fan at medium speed.

LOW: Turn on the fan at low speed.

LIGHT: ON/OFF: Press and release immediately to turn

DIMMER: Press and hold on to dim or brighten

lights to the desired level and release

(only for tungsten bulbs).