Operating Your Transmitter - NOMA 052-8687-4 Owner's Manual

Gunnar ceiling fan

Hide thumbs

Table of Contents

Toll Free 1-866-827-4985 model no. 052-8687-4

15. The slide switch on switch box sets direction of fan rotation. Select the desired direction of fan rotation.

Push the slide switch left for "Forward" and right for "Reverse" (Fig. 15).

Forward

Switch Box

NOTE:Wait for fan to stop before reversing the direction of blade rotation.

NOTE:Your fan has an energy-saving wattage limiter. If wattage exceeds 190 W,

Ensure bulb wattage is always below 190 W.

Restore power to the ceiling fan and test for proper operation.

16. Install the 9Vs battery (included). To prevent damage to transmitter,

remove the battery if not used for long periods (Fig. 16).

CODE SWITCH

CODE SWITCH: Codes are set by pushing dip switches up or down.

It is imperative that the code used for both transmitter and receiver

is exactly the same; otherwise remote

Please note the code switch will enable you to operate a second remote

controller independently. For example, if you have two ceiling fans with

/receiver. This will enable you to operate each ceiling fan independently.

Your remote control is ready for use after battery installation.

Restore power to ceiling fan and test for proper operation.

The fan remote control controls the fan setting:

HI: Turn on the fan at high speed.

MED: Turn on the fan at medium speed.

LOW: Turn on the fan at low speed

LIGHT: ON/OFF: Press and release immediately to turn

DIMMER: Press and hold on to dim or brighten

Slide Switch

Reverse

Fig. 15