Drilling; Rotate The Drilling Block; Empty The Paper Chips - Challenge Handy-Drill Instructions And Parts Manual

7.0 Operation

7.3 Drilling

After the machine has been properly installed and adjusted, it is ready for drilling. Set the side stop to
the first position and jog stock against the backgauge and side guide. Switch on the machine by
pressing the rocker switch to "I". Pull the handle to start the motor and drill. Pull the handle until the
stock is drilled through. Raise the handle to its starting position. The motor will automatically shut off.
Lift the side stop lever and slide the side stop to the next position. Continue drilling as described
above.

7.4 Rotate the Drilling Block

As the drilling block wears, the bottom few sheets may not be cut through. Rotating the drilling block
to a new position will correct this. The drilling depth may also need adjustment. After the drilling
block has been worn in all the available area on one surface, it may be turned over to use the other
surface.

7.5 Empty the Paper Chips

The paper chip collectors should be emptied periodically. Check the level of paper chips in the
collectors by looking through the sight gauge on the left collector. Switch off the machine before
emptying the collectors. To remove the collectors, pull them apart from each other. Reinstall the
collectors after emptying. Two safety switches prevent the motor from operating with the chip
collectors removed. Switch on the machine when ready for use.
12