Specifications; Dmx Channels - IMG STAGE LINE PARL-30SPOT Instruction Manual

7.2.2 Address adjustment via the controller
With this method, any start address desired can easily
be assigned to a spotlight:
1) At the controller, set the DMX value of the channel
corresponding to the start address to be adjusted to
the maximum (255) . Set the values of all other DMX
channels to zero . For adjusting, e . g . start address
17, fully advance channel 17 on the controller and
set all other channels to zero .
2) On all spotlights to which this start address is to be
assigned, shortly press the button DMX ADDRESS
SETTING (5) .
Repeat these operating steps until an address has been
assigned to each spotlight .
7.3 Control with LED-4C
The unit LED-4C by IMG STAGELINE is an easy-to-use
controller specially designed for these LED spotlights .
It is equipped with 4 channels so that all spotlights
connected to it can only be controlled in sync .
Set the start address of the spotlights to 1 or to
a multiple of 4 + 1 (5, 9, 13, ... 61 max .),
ter 7 .2 .1 . Detailed information for operation can be
found in the manual of LED-4C .
8 Cleaning the Spotlight
The plastic pane of the spotlight cover (10) should be
cleaned at regular intervals from the outside, and if
necessary, also from the inside, depending on impuri-
ties caused by dust, smoke, or other dirt particles . Only
this will ensure that the light is emitted at maximum
brightness .
1) For cleaning use a soft, clean cloth and a mild
detergent . Then wipe the plastic plane dry .
2) For cleaning the pane from the inside, remove the
spotlight cover (10) .
CAUTION! Always disconnect the mains plug from
the socket before opening the spotlight .
a) Release the locking screw (11) and slide the latch
(12) to the rear .
b) Slightly turn the spotlight cover counter-clock-
wise so that it will unlock and can be removed .
c) Clean the pane from the inside and reassemble
the spotlight in reverse order .
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
☞
chap-
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®

9 Specifications

Power supply: . . . . . . . . .230 V/ 50 Hz
Power consumption: . . . .10 VA
Light source: . . . . . . . . . .extra bright 5 mm LEDs
Number: . . . . . . . . . . .90
Beam angle: . . . . . . . . . .20°
Ambient temperature: . . .0 – 40 °C
Dimensions . . . . . . . . . . .⌀ 120 mm × 120 mm
Weight: . . . . . . . . . . . . .1 kg
Cable length: . . . . . . . . .1 .2 m

9.1 DMX channels

DMX value Function
Channel 1: proportion of red
0 – 255 brightness of red
Channel 2: proportion of green
0 – 255 brightness of green
Channel 3: proportion of blue
0 – 255 brightness of blue
Channel 4: dimmer / stroboscope/ music
0 – 7 LEDs off
8 – 190 dimmer
music-controlled change of
191 – 200 colour via integrated micro-
phone
stroboscopic effect:
201 – 247
slow
248 – 255 full brightness
Subject to technical modification .
red: 24
green: 33
blue: 33
 fast
11