Power Locks - DaimlerChrysler SPRINTER2006 Service Manual

VA
POWER LOCKS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
POWER MIRRORS . . . . . . . . . . . . . . . . . . . . . . . . . 3
DOOR LOCK MOTOR
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . 1
REMOTE KEYLESS ENTRY TRANSMITTER
DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . 1
MASTER LOCK SWITCH
DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . 1
DOOR LOCK MOTOR
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the door trim panel.
(3) Remove the door lock.
(4) Remove the door lock motor from the door lock.
INSTALLATION
(1) Install the door lock motor to the door lock.
(2) Install the door lock.
(3) Install the door trim panel.
(4) Connect the battery negative cable.
REMOTE KEYLESS ENTRY
TRANSMITTER
DESCRIPTION
Pressing the unlock button on the transmitter will
unlock the drivers door, pressing it a second time
within 2.5 seconds will unlock all other doors. The
transmitter has a range of 10 meters. A key is inte-
gral to the transmitter.
When a transmitter is lost, it is necessary to dis-
able the affected transmitter so that it can no longer
be used to operate the vehicle. It will then be neces-
sary to program a new transmitter to the vehicle.
POWER SYSTEMS
TABLE OF CONTENTS
page
POWER WINDOWS. . . . . . . . . . . . . . . . . . . . . . . . . 5

POWER LOCKS

TABLE OF CONTENTS
page
DIAGNOSIS AND TESTING - MASTER LOCK
SWITCH
REMOVAL
INSTALLATION
MASTER LOCK SWITCH
DESCRIPTION
The master lock switch is a momentary contact
switch. Pressing the once in the up direction unlocks
the driver door. Pressing it again in the same direc-
tion unlocks all doors. Pressing the button in the
down direction locks all doors.
DIAGNOSIS AND TESTING - MASTER LOCK
SWITCH
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the switch to be tested.
(3) Using an ohmmeter, test switch for continuity
(Fig. 1).
(4) If test results are not obtained as shown in the
test table, replace the switch.
POWER SYSTEMS 8N - 1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
. . . . . . . . . . . . . . . . . . . . . . . . . . 2
page
page