DaimlerChrysler SPRINTER2006 Service Manual page 79

VA
TURN SIGNAL LAMPS
When the left (lighting) control stalk of the multi-
function switch is activated (Fig. 1), the turn signal
system illuminates the selected right or left turn sig-
nal indicator and the turn signal lamps begin to
flash. The turn signal lamps include a bulb integral
to each front lamp unit and each tail lamp unit, as
well as a repeater lamp bulb located on each front
fender above the front wheels. When the turn signal
system is activated, the turn signal switch circuitry
within the multi-function switch and the electronic
circuitry of the wipers, turn signals and engine start
control module within the fuse block will repeatedly
energize and de-energize the turn signal relay
located in the fuse block. The turn signal relay
switches battery current from a fused ignition switch
output fuse in the fuse block to the appropriate turn
signal indicator and turn signal lamps.
The ElectroMechanical Instrument Cluster (EMIC)
contactless relay will generate repetitive, audible
turn signal "click" sounds to emulate the sounds of a
conventional electro-mechanical turn signal flasher
at one of two rates to coincide with the flashing of
the turn signals. The slow rate emulates normal turn
signal operation, while the fast rate emulates "bulb
out" turn signal operation.
SPECIFICATIONS - LAMPS / LIGHTING - EXTE-
RIOR
BULB SPECIFICATIONS
LAMP
Backup
Brake & Rear Park
Center High Mounted
Stop
Clearance
Front Fog
Front Position
Front Turn, Park & Side
Marker
Low Beam Headlamp
High Beam Headlamp
License Plate
Rear Side Marker
Rear Turn
Side Repeater
BULB
P21W - 12V 21W
P21/5W - 12V 21/5W
P21W - 12V 21W
W3W - 12V 3W
H1 - 12V 55W
W5W - 12V 5W
3457 NA - 12V 28/7.5W
Amber Glass
H7 - 12V 55W
H1 - 12V 55W
C5W - 12V 5W
R5W - 12V 5W
P21W - 12V 21W
W5W - 12V 3W
LAMPS/LIGHTING - EXTERIOR 8L - 5
BACKUP LAMP BULB
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) If the vehicle is so equipped, remove the trim
from the inside of the right or left rear corner pillar.
(3) From inside the vehicle, use hand pressure to
push the two latch tabs toward the center of the tail
lamp unit socket plate and pull the socket plate
straight out from the inner rear pillar (Fig. 2).
Fig. 2 Tail Lamp Socket Plate Remove/Install
1 - SOCKET PLATE
2 - INNER REAR PILLAR
3 - LATCH TAB (2)
(4) Pull the socket plate away from the inner rear
pillar far enough to access the backup lamp bulb
(Fig. 3).