Emissions Control - DaimlerChrysler SPRINTER2006 Service Manual

VA
EVAPORATIVE EMISSIONS . . . . . . . . . . . . . . . . . . 1
CRANKCASE VENTILATION HEATER
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . 1
CRANKCASE VENTILATION BREATHER
DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . 2
CRANKCASE VENTILATION
HEATER
REMOVAL
(1) Disconnect the negative battery cable.
(2) Remove the turbocharger heat shield.
(3) Disconnect the CCV heater wiring harness con-
nector.
(4) Using a slight twisting motion, separate the
CCV breather tube from the heater.
(5) Separate the CCV heater from the turbo-
charger air inlet duct.

EMISSIONS CONTROL

TABLE OF CONTENTS
page
EVAPORATIVE EMISSIONS
TABLE OF CONTENTS
page
EMISSIONS CONTROL 25 - 1
EXHAUST GAS RECIRCULATION
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Fig. 1 CCV HEATER
1 - BREATHER HOSE
2 - HARNESS CONNECTOR
3 - TURBOCHANGER INLET HOSE
4 - HEATER ALIGNMENT AREA
5 - CCV HEATER
INSTALLATION
(1) Clean all mating surfaces.
(2) Insert the CCV heater into the turbocharger
inlet hose aligning the arrow on the heater with the
tab on the hose (Fig. 1).
(3) Connect and properly seat the CCV breather
hose on the CCV heater (Fig. 1).
page
. . . . . . . . . . . . . 4
page