Turning On The Server - NEC Express5800/T110g-S User Manual
Express server express5800 series
Hide thumbs
Also See for Express5800/T110g-S:
- System configuration manual (35 pages) ,
- Configuration manual (34 pages) ,
- Getting started (2 pages)
Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Turn on the server by using the following procedure.
1. Disconnect Flash FDD if applicable.
2. Turn on the peripheral devices such as display unit.
3. If POWER LED lights amber, wait until POWER LED is unlit.
4. Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, the
NEC logo appears on the display.
While the NEC logo is being displayed, the
self-diagnostic program (POST) runs and diagnoses the
hardware. For details, see Chapter 3 (1.1 POST).
Important
Wait for at least 10 seconds before turning on the server again after the
power has been turned off.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Express5800/T110g-S User's Guide
1. Turning on the Server
POWER
Switch
POWER
LED
109
Advertisement
Table of Contents
