NEC Express5800/T110g-S User Manual page 65
Express server express5800 series
Hide thumbs
Also See for Express5800/T110g-S:
- System configuration manual (35 pages) ,
- Configuration manual (34 pages) ,
- Getting started (2 pages)
Table of Contents
Advertisement
Chapter 2 Preparations
Connecting the flash backup unit control cable
To connect the flash backup unit control cable into the flash backup unit, see the following figure.
Check the form of the connector and connect the cable straight into the connector.
Getting ready to install the flash backup unit
1.
See Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and the front bezel, see Chapter 2 (1.4 Removing the Side Cover and
1.5 Removing the Front Bezel).
Installing the flash backup unit
1.
Remove one screw from the front panel bracket.
2.
Slide the front panel bracket slightly toward the right, and then pull the bracket toward the front to
remove it.
Important
Be careful that the cable does not come out from the connector when pulling
the front panel bracket.
Express5800/T110g-S User's Guide
1. Installing Internal Optional Devices
65
Advertisement
Table of Contents
