NEC Express5800/T110g-S User Manual page 63

Chapter 2 Preparations
Arrange the battery cable as shown in
the figure.
4. Draw the cable into the chassis and mount the front panel bracket on the server chassis in the
reverse order of the removal procedure.
Connecting to a RAID Controller
1. Connect another connector of the battery control cable to the connector on the RAID controller.
Check the form of the connector and connect the cable straight into the connector. Be careful not
to press it in at an angle when connecting.
Position of the connector
Connect the cable to the connector shown in the figure below.
With cable tie attached, fixed the battery
cable to the bracket as shown in the figure.
Connector for battery control cable
Rear face of RAID controller
Express5800/T110g-S User's Guide
1. Installing Internal Optional Devices
63