Presetting Stations In Dab And Fm Modes - Sangean DDR-66BT Instruction Manual

Presetting stations in DAB and FM modes

There are 10 memory presets each for DAB and FM radio. They are used in the same way for each
operating mode.
1. Press the Standby button to switch on your radio.
2. Tune to the required radio station as previously described.
3. To store the station as a preset, press and hold the required Preset button (1 - 10) until the display
shows 'Preset stored'. The station will be stored under the chosen preset button. Repeat this
procedure as needed for the remaining presets.
Alternatively, press and hold the Preset button on the panel to enter the preset setting menu.
Then press the Tuning up/down button to select the required Preset number. Press the Select
button to store the preset station. "Preset stored" will show on the display indicating the station
is stored under the selected preset number.
4. Stations which are already stored in the presets may be over written by following the above procedure.
Note:
The radio station presets are retained in memory when the radio is switched off and disconnected
from the mains supply.
Recalling a preset in DAB and FM modes
1. Press the Standby button to switch on your radio.
2. Select the required operating mode using the Radio button.
3. Momentarily press the required Preset button. Your radio will then tune to the station stored in
the selected preset memory. The chosen preset number is also shown in the lower area of the
radio display, e.g. 'P2'.
4. Alternatively in FM radio mode only, use the Folder Up or Down buttons (on the remote control)
to access FM presets already stored.
FM 12:34
Heart FM
GB
Heart FM - The
Best Variety of
FM Radio
Hits
Preset stored
FM 12:34
Heart FM
Heart FM - The
Best Variety of
FM Radio
Hits
2
70