Stereo/Mono Switching; Presetting Stations In Dab And Fm Modes - Sangean REVERY R4 WFS-58 User Manual

Stereo/Mono switching

If the FM radio station being listened to has a weak signal, some hiss may be audible. It is possible to
reduce this hiss by forcing the radio to play the station in mono rather than stereo.
1. Press and release the Band button as needed and then use the Menu Up or Down and Select
buttons to select the FM Radio mode. Tune to the required FM station as previously described.
2. Press and hold the Menu button to enter the FM menu.
3. Press the Menu Up or Down buttons until 'Audio setting' is highlighted on the display. Press and
release the Select button to enter the audio setting mode. The current setting is indicated with an
asterisk.
4. To switch to mono in order to reduce the hiss from a weak FM signal press the Menu Left or
Right buttons until 'YES' is highlighted. Press and release the Select button to confirm the setting.
Alternatively, to return to the normal automatic 'stereo or mono' mode press the Menu Left or Right
buttons until 'NO' is highlighted. Press and release the Select button to confirm the setting.
5. Press the Back button to return to the normal FM mode display.
Presetting stations
Your radio has ten memory presets each for DAB and FM radio. They are used in the same way for
each operating mode.
The radio station presets are retained even when the radio is switched off.
40
FM
radio
FM Radio
FM
Scan setting
Audio setting
System settings >
Main menu >
FM weak reception
Listen in Mono only?
YES NO