2.2.8. CPU and System Fan Connectors
There are two fan connectors on board: one for the CPU and one for the chassis. The fan connector for
the CPU is labeled as "CPUFAN1" and the fan connector for the system is labeled as "SYSFAN1". The fans
provide variable fan speeds controlled by the BIOS. The pinout of the fan connectors are shown below.
SYSFAN1
1
Figure 22: CPU and System fan connector diagram
CPU fan (CPUFAN1)
Pin
1
F_I01
2
F_PWM1
3
GND
Table 19: CPU and System fan connector pinout
2.2.9. SATA Connector
The two SATA connectors on board can support up to 3 Gb/s transfer speeds. The SATA connectors are
labeled as "SATA1" and "SATA2". The pinout of the SATA connectors are shown below.
Figure 23: SATA connector diagram
Pin
1
2
3
4
5
6
7
Table 20: SATA connector pinout
Note:
If users want to use the SATA Disk-on-Module flash drive on the board, please use the SATA2 connector.
System fan (SYSFAN1)
Signal
Pin
1
2
3
SATA1
Signal
Pin
GND
1
STXP_0
2
STXN_0
3
GND
4
SRXN_0
5
SRXP_0
6
SATA1_+5V
7
EPIA-M920 User Manual
CPUFAN1
1
Signal
F_I02
F_PWM2
GND
SATA2
Signal
GND
STXP_1
STXN_1
GND
SRXN_1
SRXP_1
SATA2_+5V
19