Add The Lock To Your Smart Home System; Add User Codes (30 Max); Test The Lock (Review Normal Operation); Re-Key The Lock (If Needed) And Install The Battery Cover - Kwikset Smartcode 914 Installation And User Manual

6

Add the lock to your smart home system

A
Initiate the process to add
the lock to your system at
your smart home controller.
Refer to your smart home
system instructions for
more information.
7

Add user codes (30 max)

It is recommended that you add and
A
Make sure the door is open. Press
delete all user codes through your smart
the Program button once.
home control system. If your system
does not allow this, codes may be added
directly to the lock as shown here.
Programming Timeout
During programming, if no button is
pressed for ive seconds, the system will
time out (indicated by three beeps and a
red lashing keypad), and you will need to
restart the procedure.
D
What lights and sounds does the lock produce?
Mastercode
For enhanced security,
a mastercode may
be used when adding
and deleting user
codes. For more
information about the
mastercode, download
the Programming and
Troubleshooting Guide
on the SmartCode 914
page at kwikset.com.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon. See "Switches and Status LED Colors" on page 4.

Test the lock (review normal operation)

8
Con irm that the code(s) added in previous step can unlock the door.
Locking the Door
Press Lock button once.
9

Re-key the lock (if needed) and install the battery cover

A
Re-key the lock (if needed).
a
b
K
IMPORTANT: Re-key the lock
Remove battery to work with your
pack before existing key. See
re-keying. the supplied
SmartKey Re-key
instructions for
more information.
B
When prompted by your smart home system to add the
lock, press button "A" on the lock interior one time. The
red LED will illuminate when the lock enters Add Mode.
button "A"
Please allow time for the controller to add the lock.
B
Enter user code. A total of 30 user
codes may be programmed.
One green lash with one beep
green
1x
Programming was successful.
c
Reinstall
battery
pack.
H
3 / 4
C
If successful, re-name the lock in your system
(if applicable).
D
If unsuccessful, follow your system's instructions to
remove the lock from the controller and any other
network, then press button "A" on the lock one time.
Perform steps 6A 6C again.
If still unsuccessful, consult the Programming and
Troubleshooting Guide on the SmartCode 914 page
at www.kwikset.com.
C
Each user code
must be a unique
code between
4 and 8 digits,
depending on
your smart
home system.
Three red lashes with three beeps
or
red
Programming was unsuccessful.
Make sure not to pause for more than 5 seconds during programming.
Make sure the user code is not a duplicate and that it is between 4 and 8 digits
during your next attempt. Make sure the lock has room for an additional code.
If all user code positions are illed, delete a code to make room for this one.
Unlocking the Door
Enter user code.
Tip: You can press the
Lock button before
entering your user
code to light up the
keypad at night.
B
Install the battery cover.
a
K
M
Press Lock button once.
3x
actual
size
V
b
V (3x)