GE C30 Instruction Manual page 467

APPENDIX G
Table G–4: MAJOR UPDATES FOR C30 MANUAL REVISION Z1
PAGE PAGE CHANGE
(Y3) (Z1)
--- --- Add
--- --- Add
1-1 1-1 Add
1-5 1-5 Update
2-8 2-8 Update
5-20 5-20 Add
5-78 5-78 Update
5-82 5-82 Update
5-124 5-124 Add
Table G–5: MAJOR UPDATES FOR C30 MANUAL REVISION Y3
PAGE PAGE CHANGE
(Y2) (Y3)
-- ix Add
Table G–6: MAJOR UPDATES FOR C30 MANUAL REVISION Y2
PAGE PAGE CHANGE
(Y1) (Y2)
All All Update
All All Delete
1-1 1-1 Update
3-8 3-8 Update
Table G–7: MAJOR UPDATES FOR C30 MANUAL REVISION Y1 (Sheet 1 of 2)
PAGE PAGE CHANGE
(X2) (Y1)
All All Delete
Title Title Update
1-1 1-1 Update
2- 2- Add
2- 2- Delete
3-10 3-10 Update
2-12 2-12 Update
3-21 3-21 Update
5-1 5-1 Update
5-11 5-11 Update
5-11 5-11 Delete
GE Multilin
DESCRIPTION
Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
Added General Cautions and Warnings to section 1.1.1
Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-21 and 5-22 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-23 Disconnect Switch Scheme Logic
Reinserted section 5.7.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
DESCRIPTION
Added battery disposal information as chapter 0
DESCRIPTION
Minor changes throughout document
Deleted CPU options U and V
Updated Figure 1-1 Rear Nameplate
Updated Figure 3-10 Rear Terminal View
DESCRIPTION
Deleted content pertaining to Ethernet switch
Changed part numbers. Updated address and contact information.
Updated address and contact information
Added CPU options T, U, and V to order code tables
Deleted E, G, H, J, S from CPU options from order code tables. Deleted 9S, 2S, 2T from
replacement module order code tables.
Updated Figure 3-12 Typical Wiring Diagram
Updated Ethernet fiber table in section 2.2.6 Communications
Deleted references to COM 1 RS485 port in section 3.2.8 CPU Communication Ports. Revised
text and Figure 3-22 CPU Module Communications Wiring to include only modules T, U, V in
section 3.2.8a.
Updated the front panel main menu to include the CyberSentry security menu
Updated Communications main menu to remove the SNTP Protocol submenu
Deleted references to COM 1 RS485 port in section 5.2.4b Serial Ports
C30 Controller System
G.1 CHANGE NOTES
G
G-3