Advertisement
AT&T Internet
Wi-Fi
Gateway Replacement
®
Reminder:
· Your Wi-Fi Gateway does not contain a battery backup.
· Battery backup is available for purchase from third-party manufacturers
and retailers to keep you connected in the event of a power failure. Visit
att.com/batterybackup
Get started
These instructions will guide you through the process of replacing your Wi-Fi Gateway.
In the box:
for more information.
Wi-Fi
Gateway
(Front View)
Approximate installation time: 20 minutes
Power Cord
(2 parts)
Warning: Use only the power supply & cord that
came with this device. Failure to use the authorized
power supply & cord may cause electric shock, fire,
bodily injury and/or property damage.
BGW210 with Voice Swap Guide
02/17
self-
installation
guide
ATT162550933
Advertisement
Table of Contents
Related Manuals for Arris BGW210
Summary of Contents for Arris BGW210
-
Page 1: Get Started
Warning: Use only the power supply & cord that came with this device. Failure to use the authorized power supply & cord may cause electric shock, fire, bodily injury and/or property damage. Wi-Fi Gateway (Front View) BGW210 with Voice Swap Guide 02/17 ATT162550933... - Page 2 Power up Set up Approximate time: 1–5 minutes Approximate time: 10 minutes Your Wi-Fi Gateway is now powering up. During this time (up to 5 minutes), do not disconnect the power cord or unplug any cables connected to this device. This can Please note that your U-verse TV, Internet, and voice services will not operate during this process.
-
Page 3: Additional Information
Need more help? No TV or Internet service: Check your connections: If your existing Wi-Fi settings did not transfer, you will need to set up a new Wi-Fi Network Name Cables usually make an and Password. audible click when secure. ·...
Need help?
Do you have a question about the BGW210 and is the answer not in the manual?
Questions and answers
Change from wep to wpa2
To change the Arris BGW210 from WEP to WPA2, follow these steps:
1. Login to the Router:
- Open a web browser and enter the router's IP address.
- Use the required username and password to log in.
2. Access WiFi Settings:
- Click on "Home Network" at the top of the page.
- Select the "Wi-Fi" option below it.
3. Change Encryption Type:
- Locate the security settings for your WiFi network.
- Change the encryption type from WEP to WPA2.
4. Save Changes:
- Apply the new settings and restart the router if needed.
Your WiFi should now be secured with WPA2 encryption.
This answer is automatically generated
red broadband light is on, can't get it off Router # BGW210
I have model BGW210 I have a black cable in my modem where should I connect it.