Maintenance; Changing The Battery; Figure 14: Changing The Battery - Bosch TDL 110 Operating Instructions Manual

Transport Data Logger | TDL 110

6 Maintenance

6.1 Changing the Battery

The battery is accessible from the bottom of the TDL.

Figure 14: Changing the battery

1 Screws (4x Torx T6); Torque 0.5 Nm
2 Mounting plate
3 Battery
4 TDL
Notice
No data can be measured or stored while the battery is being changed.
▶ Always stop logging before removing the battery.
1. Stop logging. If desired transfer the data to your smartphone (refer to chapter
Reading the Data).
2. Place the TDL down so that its bottom is facing upwards.
3. Remove the four screws by using a Torx T6 screwdriver.
4. Remove the mounting plate.
5. Change the battery (CR 123A Lithium Battery).
6. Position the mounting plate on the TDL.
7. Fasten the four screws with a torque of 0.5 Nm.
8. The TDL is now ready for use and can be configured (see chapter
Caution
Liquid which enters the device can cause short circuits and damage the device. This could
cause fire, data loss and incorrect measurements.
▶ Ensure that the battery cover is positioned correctly.
▶ Always fasten the screws with a torque of 0.5 Nm.
Risk of Data Loss
Damage to Materials can cause Risk of Fire!
17 | 21
1
2
3
4
5.4.1
5 Operation).