Logging Interval; Settings; Figure 9: Change Settings; Table 5: Logging Intervals - Bosch TDL 110 Operating Instructions Manual

Transport Data Logger | TDL 110

5.2.1 Logging Interval

Required Monitoring Time
1 month
3 months
6 months
9 months
12 months
15 months
18 months
21 months
24 months

Table 5: Logging Intervals

These recommendations are based on assumptions, made for a specific number of shocks and
tilts per day.
At the end of the monitoring period the stored data can be analyzed and then cleared. The
measurement can be started from scratch again. For logging intervals that are longer than
15 minutes, the battery with a lifetime of 24 months will be the limiting factor.

5.3 Settings

You can change the settings of your TDL at any time. Any change to the settings is protected
by the PIN. To change settings, please connect to the respective TDL. Logging is stopped
during the TDL configuration.
1. Connect to a previously configured TDL.
2. Swipe down to "Settings".
3. Tap on the desired setting and make the changes.
Recommended Logging Interval
1 min
2 min
4 min
6 min
7 min
10 min
12 min
13 min
15 min

Figure 9: Change settings

12 | 21