Changing The Setup; Changing The Pin; Clearing The Data; Reset - Bosch TDL 110 Operating Instructions Manual

Transport Data Logger | TDL 110

5.3.1 Changing the Setup

1. Tap "Change Setup" to set new values.
2. When ready, tap "Change" to apply the new changes.
Notice
The log files are associated with a specific shipment. Data logging can be
interrupted upon request by tapping "Stop logging".
▶ The data recording will continue and data will be stored in the
same file as long as the settings remain unchanged.
▶ The logging starts over and the data will be stored in a new file if
you change settings.

5.3.2 Changing the PIN

1. Tap "Change PIN" to set a new PIN.
2. Set the new PIN and re-enter the new PIN.
3. When ready, tap "Change" to apply the new PIN.
Notice
You cannot configure the TDL without a valid PIN. It is impossible to
reset the PIN; even at the factory.
▶ Always make a note of the PIN and store it in a safe place.

5.3.3 Clearing the Data

1. Tap "Clear Data" to clear the logging data. A new window "Do you want to clear all logged
data stored on the TDL?" appears.
2. Tap "Clear" to clear the data.

5.3.4 Reset

1. Tap "Reset". A new window "All setup and logged data will be cleared. Do you want to
continue?" appears. After the reset the device will be in the delivery state.
2. Tap "Reset".
3. The LED blinks red three times to confirm the reset.
.
Storage of Measurement Data
No TDL Access!

Figure 10: Change setup

13 | 21

Figure 11: Change PIN