Qflex 24 & Qflex 32 Assembly - Tannoy QFLEX User Manual

10.3 QFLEX 24 & QFLEX 32 ASSEMBLY
It is recommended that you assemble the column horizontally on a flat surface. Lay some cloth or cardboard on the
surface to avoid scratching the surface of the product during the assembly process.
In the hardware pack you will find one wall bracket and joining hardware consisting of one heavy joining plate with hinge
points, two small link bars and M4 Phillips screws.
Place each module in its respective position on the assembly area keeping them slightly spaced apart. Take the flying
RJ45 connector in the lower module and insert it into the RJ45 socket in the upper module. Take the flying AC mains
connector in the lower module and insert it into the female connector in the upper module.
CAT 5
POWER CORD
Align the two columns together as shown below.
Having the hinge points on either side of the QFlex column allow the loudspeaker to be rotated at 90 degrees to the
mounting structure allowing easy access to the input connector panel.
The installer must ensure that the mounting surface is capable of safely and securely supporting the loudspeaker. Seek
help from architects, structural engineers or other specialists if in any doubt.
A
STAGE 3
Attach the joining plates in the three stages as shown. Only one wall
bracket it required to mount the two modules. For flexibility the wall
bracket can be mounted to either the top or the bottom column. The
wall bracket can be hinged on the left or right pivot points. 3mm Allen
grub screws allow the QFlex to be locked at the desired
horizontal angle.
STAGE 2
STAGE 1