Operating Mode - Tannoy QFLEX User Manual

8.22 OPERATING MODE

A control input on the back of the loudspeaker allows you to select between two different sets of DSP settings (1 and 2)
– see system connectivity. The currently active Operating Mode is indicated by the 'Active' box in the OpMode group box
in the PodWare panel. You can select which Operating Mode you wish to edit by selecting the appropriate radio-button
in the OpMode group box. Both modes may be edited simultaneously by selecting 'Edit Both'. Only when the Operating
Mode is the same as the edited mode will changes you make be heard. Note however that if you make adjustments
on the control panel when the active mode is different to the edit mode, the settings are changed and stored in the
loudspeaker, but you will not be able to hear the changes until the active mode is changed to the one you have edited. A
red indication will be shown in the OpMode group box when you are not listening to the mode you are editing.
Note that Parameter adjustments are automatically stored in the loudspeaker - it is not possible to do temporary changes
then store them separately.
Example - Op Mode 1 with a particular EQ setting.
Input B Muted
Example – Op Mode 2 with an EQ setting for emergency paging.