Assembly Instructions; Cut-Out; Connections - Tannoy CMS50 User Manual

3. Assembly Instructions

3.1. Cut-Out

The cut-out size required is 210mm.

3.2. Connections

The CMS50 ICT is provided with a pluggable European type connector, which is
located on the back of the speaker can, under the wiring cover as shown in Figure 3a
below. This consists of a plug and socket. The plug can be removed from the socket
(Figure 3b) for wiring.
To cable is inserted into the hole on the side of the plug, and the screw is tightened to
secure the cable in the plug. The plug is wired to the amplifier such that the
connections are as follows:
Pin 1 is Positive - connect to Red
Pin 2 is Negative - connect to Black
For additional speakers, pin 3 and 4 are in parallel with pins 1 and 2, where:
Pin 3 is Positive
Pin 4 is Negative
Before connecting the speaker, ensure the wiring cover and cable clamp on the back
of the can are open as shown in Figure 3c. Connect the wired plug into the socket.
Once the plug has been connected, close the wiring cover as shown in Figure 3d,
below:
6
Figure 3a
Figure 3c
Figure 3b