Arp Mad-Enabled Irf Configuration Example For A Two-Chassis Irf Fabric - HP 12500 SERIES Configuration Manual

# After the IRF merge is complete, verify that the IRF fabric is recovered.
<Sysname> display irf topology
-------------------------------------------------------------------------
MemberID
2
1
ARP MAD-enabled IRF configuration example for a
two-chassis IRF fabric
Network requirements
Set up a two-chassis IRF fabric at the distribution layer of the enterprise network in
Configure ARP MAD for the IRF fabric and use Device C as an intermediate device. Device C can
come from any vendor.
To prevent loops, enable the spanning tree feature between the IRF fabric and Device C.
Figure 18 Network diagram
Configuration procedure
Configure Device A:
1.
# Assign member ID 1 to Device A and bind Ten-GigabitEthernet 3/0/1 to IRF-port 2.
<Sysname> system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the member reboots and operates in IRF
mode.
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
[Sysname] irf-port 2
Topology Info
IRF-Port1
Link neighbor
DOWN --
UP 2
IRF-Port2
Link neighbor
UP 1
DIS --
45
Belong To
00e0-fc0f-8c02
00e0-fc0f-8c02
Figure 18.