Configuration Procedure; Multiport Arp Entry Configuration Example; Network Requirements - HP 5920 Series Configuration Manual

Figure 3 Network diagram

Configuration procedure

# Create VLAN 10.
<Switch> system-view
[Switch] vlan 10
[Switch-vlan10] quit
# Add interface Ten-GigabitEthernet 1/0/1 to VLAN 10.
[Switch] interface Ten-GigabitEthernet 1/0/1
[Switch-Ten-GigabitEthernet1/0/1] port access vlan 10
[Switch-Ten-GigabitEthernet1/0/1] quit
# Create VLAN-interface 10 and configure its IP address.
[Switch] interface vlan-interface 10
[Switch-vlan-interface10] ip address 192.168.1.2 8
[Switch-vlan-interface10] quit
# Configure a static ARP entry that has IP address 192.168.1.1, MAC address 00e0-fc01-0000, and
output interface Ten-GigabitEthernet 1/0/1 in VLAN 10.
[Switch] arp static 192.168.1.1 00e0-fc01-0000 10 Ten-GigabitEthernet 1/0/1
# Display information about static ARP entries.
[Switch] display arp static
IP Address
192.168.1.1

Multiport ARP entry configuration example

Network requirements

As shown in
Ten-GigabitEthernet 1/0/2, and Ten-GigabitEthernet 1/0/3 in VLAN 10. The servers share the IP
address 192.168.1.1/24 and MAC address 00e0-fc01-0000.
Type: S-Static
MAC Address
00e0-fc01-0000
Figure 4, a switch connects to three servers through interfaces Ten-GigabitEthernet 1/0/1,
D-Dynamic M-Multiport
VLAN ID Interface
10 XGE1/0/1
7
I-Invalid
Aging Type
N/A S