Epson SureColor SC-S70600 series Operator's Manual page 16

EPSON SC-S70600 series/SC-S50600 series
❏ Selected Media
Displays the parameters on which media settings
are based as shown below.
RIP Settings: Media settings are based on those
in the RIP.
XXXXXXXXXXXXXXXXXX: Media settings
are based on those stored in the printer in media
settings bank No. 1.
Media settings banks can store a variety of settings
for different media based on the options selected in
the Heater Temperature, Media Suction, Head
Alignment, and other menus. Up to
30 combinations of settings can be stored by
assigning them to banks No. 1 to 30.
Media Settings U User's Guide (PDF)
Buttons that are used in the following settings
A
Select an option.
To print at current settings:
Use the d/u buttons to select Keep Settings
Above and press the Z button.
Proceed to Step 6.
To change settings:
Use the d/u buttons to select Change Settings
and press the Z button.
B
Select the items you want to change and press the
Z button.
C
Select the desired option and press the Z
button.
D
Press the y button to display the dialog shown in
Step 2 and then press the y button again.
Operator's Guide
Basic Operations
E
After confirming that the settings are correct, use
the d/u buttons to select Keep Settings Above
and press the Z button.
F
The roll type selection screen is displayed.
Use the d/u buttons to select the roll type that
matches the loaded roll and press the Z button.
G
If On is selected for Remaining Setup, you will
be prompted to enter the length of the current
media.
Use the d/u buttons to choose a length between
1.0 and 999.5 m and press the Z button. You
can set in 0.5 m increments.
The printer will display Ready after a brief pause,
showing that it is ready to print. Transmit the data to be
printed from the computer.
14