Rosemount 5900 Series
3.3.2
Parabolic
Antenna
3-20
Preliminary
Mounting the Flange Ball model T30
Flange Ball
Nut
1. Use a flange of thickness 6 - 30 mm.
2. Make sure that the diameter of the
Recess
hole is 96 mm.
Make a small recess at one side of
the flange hole.
3. Put the O-ring on the flange and
insert the Flange Ball into the hole.
Make sure that the pin on the side of
the Flange Ball fits into the recess
on the flange.
4. Tighten the nut so that the Flange
Ball fits tightly to the flange (torque
50 Nm).
Reference Manual
300520EN, Rev AA
November 2009
Section 3. Installation