Motorola PTP 48600 User Manual page 204

PTP 54600 reference information
This device complies with part 15.407 of the US FCC Rules and Regulations and with
RSS-210 Issue 7 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause
undesired operation. In Canada, users should be cautioned to take note that high
power radars are allocated as primary users (meaning they have priority) of 5250 –
5350 MHz and 5650 – 5850 MHz and these radars could cause interference and/or
damage to license-exempt local area networks (LELAN).
For the connectorized version of the product and in order to reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that permitted by the
regulations. The transmitted power must be reduced to achieve this requirement.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the US FCC Rules and with RSS-210 of Industry
Canada. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can
radiate radio-frequency energy and, if not installed and used in accordance with these
instructions, may cause harmful interference to radio communications. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment on and off, the user is encouraged to correct
the interference by one or more of the following measures:
•
Increase the separation between the affected equipment and the unit;
•
Connect the affected equipment to a power outlet on a different circuit from that
which the receiver is connected to;
•
Consult the dealer and/or experienced radio/TV technician for help.
•
FCC IDs and Industry Canada Certification Numbers are listed below:
Where necessary, the end user is responsible for obtaining any National licenses
required to operate this product and these must be obtained before using the product
in any particular country. Contact the appropriate national administrations for details
on the conditions of use for the bands in question and any exceptions that might apply.
4-56
UNDER DEVELOPMENT
Chapter 4 Reference information
phn-0896_009v003
Feb 2010