2.1
Introduction
You can access most of the connectors from the top of the board as it is being
installed in the chassis. If you have a number of cards installed or have a packed
chassis, you may need to partially remove the card to make all the connections.
2.2
USB Ports (LAN1_USB12/LAN2_USB34/
USB5678/USB9
The AIMB-242 provides up to 9 USB ports. The USB interface complies with USB
Specification Rev 2.0 supporting transmission rates up to 480 Mbps and Rev 3.0 sup-
porting transmission rate up to 5 Gbps and is fuse protected. The USB interface can
be disabled in the system BIOS setup.
The AIMB-242 is equipped with two high-performance 1000 Mbps Ethernet LAN
adapters, both of which are supported by all major network operating systems. The
RJ-45 jacks on the rear panel provides convenient LAN connection.
USB9
Table 2.1: LAN LED Indicator
LAN Mode
LAN1 indicator
LAN2 indicator
AIMB-242 User Manual
LAN2_
LAN1_
USB5678
USB34
USB12
USB0506
LAN Indicator
LED1 (Right)
off for mal-link; Link (On) / Active (Flash)
LED2 (Left)
100 Mbps (On) / 10 Mbps (Off); Color: Orange
LED2 (Left)
1000 Mbps (On); Color: Green
LED1 (Right)
off for mal-link; Link (On) / Active (Flash)
LED2 (Left)
100 Mbps (On) / 10 Mbps (Off); Color: Orange
LED2 (Left)
1000 Mbps (On); Color: Green
14
USB5678