Panasonic VL-VN1700 Installation Manual page 45

•
Port: Enter the TCP Port for the SNTP Server.
Daylight Saving
•
Select whether to enable or disable summer time (daylight saving time).
User
On this screen, you can specify the settings for users and extensions for the Control Box.
When you have finished specifying the settings, click Next to continue.
Number of Users
•
User: specify the number of users.
Users Information Setting
•
WebMC Language: Select the language for the user portal site from the drop-down list.
LAN
On this screen, you can specify the settings for the LAN the Control Box is on.
The IP addresses for the Control Box, DNS server, and DSP cards can be assigned automatically through a
DHCP server or entered manually.
Notice
•
If an external DHCP server is in use, it must be able to use the "client identifier" option specified by
RFC 2131.
•
If an external DHCP server is in use, the Control Box DHCP Server feature must be disabled.
•
The Control Box will not start properly if IP addresses cannot be assigned automatically by the DHCP
server when the Control Box has been set to obtain IP addresses automatically. In this case, you
need to consult your network administrator because the DHCP server in your network may not be
running or a network failure may have occurred. If the DHCP server is not available, enter IP
addresses manually, then restart the Control Box. If the Control Box cannot be accessed over the
network, connect the PC directly to the Control Box with an Ethernet cable and access Web
Maintenance Console using a direct connection.
For details about connecting the PC directly to the Control Box, refer to "Direct Connection" in "4.2 PC
Connection".
•
The appropriate values for these settings depend on your network configuration. For details, consult
your network administrator.
Note
If the IP addresses are changed from their default values, a notice about restarting the Control Box is
displayed at the end of Quick Setup Wizard. Click OK to restart the Control Box. After the Control Box
restarts, start Web Maintenance Console again (refer to "Connecting to Web Maintenance Console" in
"4.3 Starting Web Maintenance Console").
When you have finished specifying the settings, click Next to continue.
IP Address for main unit
1.
Select the method for setting the IP address information.
•
Obtain an IP address automatically
•
Use the following IP address
2.
If you selected Use the following IP address, specify the following settings.
•
IP Address: Enter the IP address for the Control Box.
4.4.1 Quick Setup Wizard
Installation Manual 45