Panasonic VL-VN1700 Installation Manual page 11

•
Do not install the system in the following locations:
In direct sunlight and hot, cold, or humid places. (Temperature range: 0 ℃ to 40 ℃)
a.
b.
Areas where sulphuric gases may be present, such as near thermal springs.
c.
Near devices that generate high frequencies, such as sewing machines or electric welders.
d.
Locations where other objects will obstruct the area around the unit. Be especially careful to leave at
least 5 cm to the sides of the unit for ventilation.
e.
Locations where condensation can occur.
•
When the unit is mounted on a 19-inch rack, allow space of at least 5 cm to the sides of unit and at least
10 cm to the rear of the unit for ventilation of the fan.
•
Do not block the vents around the fan with cables or other objects.
•
The Storage Memory Card contains software for all the processes of the unit and all the customer data.
Therefore, do not allow unauthorised access to prevent data leakage.
•
Once you have started the unit, if you unplug the unit, do not initialise it again as described in "System
Initialisation Procedure". Otherwise, your programmed data will be cleared. To restart the unit, refer to
"6.1.3 Restarting the Control Box".
•
Before touching the unit, discharge static electricity by touching ground or wearing an earthing strap.
Failure to do so may cause the unit to malfunction due to static electricity.
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located near
the equipment and is easily accessible.
•
Slots and openings in the back and right side of the cabinet are provided for ventilation; to protect it from
overheating, these openings must not be blocked or covered. The openings should never be blocked by
placing the unit on a bed, sofa, rug, or other similar surface while in use. The unit should never be placed
near or over a radiator or other heat source. This unit should not be placed in a sealed environment
unless proper ventilation is provided.
•
When this unit is no longer in use, make sure to detach it from the rack.
•
A certified power supply cord has to be used with this equipment. The relevant national installation and/or
equipment regulations shall be considered. A certified power supply cord not lighter than ordinary
polyvinyl chloride flexible cord according to IEC 60227 (designation H05VV-F 3G 0.75 mm
used.
•
When the unit is mounted on a 19-inch rack, make sure that the installation of the unit does not cause the
temperature of the rack to exceed its limit.
•
If the unit is not installed properly using the securing correct methods, the unit may fall causing serious
damage.
•
To prevent data leakage, render the Storage Memory Card physically unusable before disposal.
•
Avoid using the same AC outlet for computers and other office equipment, as noise generated by such
equipment may hamper system performance or interrupt the system.
•
Unplug the system from its power source when wiring, and plug the system back in only after all wiring is
completed.
1.1 For Your Safety
) shall be
2
Installation Manual 11