Panasonic VL-VN1700 Installation Manual page 34

3.4.1 LAN Connection for the Main Unit
Signal Name
TRD0 (+)
TRD0 (-)
TRD1 (+)
TRD2 (+)
TRD2 (-)
TRD1 (-)
TRD3 (+)
TRD3 (-)
Note
•
Use an Ethernet cable with an RJ45 connector for connection to a switching hub. The cable should be
a CAT 5 (Category 5) or higher for 10BASE-T/100BASE-TX, or CAT 5e (Enhanced Category 5) or
higher for 1000BASE-T.
•
Make sure that all CAT 5/CAT 5e cables in use are not over 100 m in length.
•
Make sure to set the port of the switching hub that connects to the card to operate under "Auto
Negotiation" mode.
34 Installation Manual
LAN Port
Switching Hub
Ethernet Cable
Connection for 10BASE-T/100BASE-TX
Switching Hub
Pin No.
Signal Name
TX+ 1
TX- 2
RX+ 3
RX- 6
Connection for 1000BASE-T
Switching Hub
Pin No.
1
2
3
4
5
6
7
8
Control Box (LAN Port)
Pin No.
Signal Name
1 RX+
2
RX-
3
TX+
6 TX-
Control Box (LAN Port)
Pin No.
Signal Name
1 TRD0 (+)
2 TRD0 (-)
3 TRD1 (+)
4 TRD2 (+)
5 TRD2 (-)
6 TRD1 (-)
7 TRD3 (+)
8 TRD3 (-)