Nibe F1355 Operating Manual page 45

USB service outlet
The display unit is equipped with a USB socket that can
be used to update the software, save logged information
and manage the settings in F1355.
INDOOR CLIMATE
HEAT PUMP
update firmware
logging
manage settings
When a USB memory is connected a new menu (menu
7) appears in the display.
NIBE F1355
HOT WATER
USB
INFO
USB 7
Menu 7.1 - update firmware
update firmware7.1
start updating
choose another file
This allows you to update the software in F1355.
NOTE
For the following functions to work the USB
memory must contain files with software for
F1355 from NIBE.
The fact box at the top of the display shows information
(always in English) of the most probable update that the
update software has selected form the USB memory.
This information states which product the software is
intended for, the software version and general informa-
tion about them. If you wish to select another file than
the one selected, the correct file can be selected by
"choose another file".
start updating
Select "start updating" if you want to start the update.
You are asked whether you really want to update the
software. Respond "yes" to continue or "no" to undo.
If you responded"yes" to the previous question the up-
date starts and you can now follow the progress of the
update on the display. When the update is complete
F1355 restarts.
NOTE
A software update does not reset the menu
settings in F1355.
NOTE
If the update is interrupted before it is complete
(for example power cut etc.), the software can
be reset to the previous version if the OK button
is held in during start up until the green lamp
starts to illuminate (takes about 10 seconds).
Chapter 4 | Service 45