Nibe F1355 Operating Manual page 28

Menu 4.9.5 - schedule blocking
The compressor can
be scheduled to be
blocked for up to
two different time
periods here.
When scheduling is
active the actual
blocking symbol in
the main menu on
the heat pump sym-
bol is displayed.
Schedule: The peri-
od to be changed is
selected here.
Activated: Scheduling for the selected period is activated
here. Set times are not affected at deactivation.
Day: Select which day or days of the week the schedule
is to apply to here. To remove the scheduling for a par-
ticular day, the time for that day must be reset by setting
the start time to the same as the stop time. If the line
"all" is used, all days in the period are set for these times.
Time period: The start and stop time for the selected
day for scheduling are selected here.
Blocking: The desired blocking is selected here.
Conflict: If two settings conflict with each other a red
exclamation mark is displayed.
Blocking the compressor.
Blocking additional heat.
TIP
If you wish to set similar scheduling for every
day of the week start by filling in "all" and then
changing the desired days.
TIP
Set the stop time earlier than the start time so
that the period extends beyond midnight.
Scheduling then stops at the set stop time the
day after.
Scheduling always starts on the date that the
start time is set for.
Caution
Long term blocking can cause reduced comfort
and operating economy.
28 Chapter 3 | Control - Menus
Activated Schedule
schedule blocking 4.9.5
schedule 1 schedule 2
activated
all
mon
tues
wed
thur
fri
sat
sun
Day Time period Blocking Conflict
NIBE F1355