Nibe F1355 Operating Manual page 21

Menu 3.3 - add. heat info
Information about the additional heat's settings, operat-
ing status and statistics can be obtained here. No
changes can be made.
The information is on several pages. Turn the control
knob to scroll between the pages.
Menu 3.4 - alarm log
To facilitate fault-finding the heat pump operating status
at alarm alerts is stored here. You can see information
for the 10 most recent alarms.
To view the run status in the event of an alarm, mark the
alarm and press the OK button.
Menu 3.5 - indoor temp. log
Here you can see the average temperature indoors week
by week during the past year. The dotted line indicates
the annual average temperature.
The average outdoor temperature is only shown if a
room temperature sensor/room unit is installed.
When an exhaust air module (NIBE FLM) is installed, the
exhaust air temperature is shown.
To read off an average temperature
1. Turn the control knob so that the ring on the shaft
with the week number is marked.
2. Press the OK button.
3. Follow the grey line up to the graph and out to the
left to read off the average indoor temperature at
the selected week.
4. You can now select to take read outs for different
weeks by turning the control knob to the right or
left and read off the average temperature.
5. Press the OK or Back button to exit read off mode.
NIBE F1355 Chapter 3 | Control - Menus 21