Table 5: Spanning-Tree Protocol Configuration Parameters - Juniper EX9200 Features Manual

Table 5: Spanning-Tree Protocol Configuration Parameters

Field Function
General
Protocol Name Specifies the spanning-tree protocol type: STP, MSTP,
or RSTP.
Disable Disables spanning-tree protocols on the interface.
BPDU Protect Specifies BPDU protection on all edge interfaces on
the switch.
Bridge Priority Specifies the bridge priority. The bridge priority
determines which bridge is elected as the root bridge.
If two bridges have the same path cost to the root
bridge, the bridge priority determines which bridge
becomes the designated bridge for a LAN segment.
Forward Delay Specifies the number of seconds an interface waits
before changing from spanning-tree learning and
listening states to the forwarding state.
Hello Time Specifies the time interval in seconds at which the
root bridge transmits configuration BPDUs.
Max Age Specifies the maximum-aging time in seconds for all
MST instances. The maximum aging time is the
number of seconds a switch waits without receiving
spanning-tree configuration messages before
attempting a reconfiguration.
Copyright © 2017, Juniper Networks, Inc.
Click one of the following options:
2.
—Creates a spanning-tree protocol configuration.
Add
Select a protocol name.
a.
Enter information as described in
b.
Click to apply changes to the configuration or click
OK
c.
saving changes.
—Modifies a selected spanning-tree protocol configuration.
Edit
Enter information as described in
a.
Click OK to apply changes to the configuration or click
b.
saving changes.
Delete —Deletes a selected spanning-tree protocol configuration.
Table 5 on page 29.
Cancel
Table 5 on page 29.
Cancel
Your Action
None.
To enable this option, select the check box.
To enable this option, select the check box.
Select a value from the list.
Type a value.
Type a value.
Type a value.
Chapter 1: Using RSTP
to cancel without
to cancel without
29