Publickey Authentication Enabled Sftp Client Configuration Example - H3C S5830V2 Security Configuration Manual

NOTE:
PSFTP supports only password authentication.
To establish a connection to the SFTP server:
a. Run the psftp.exe to launch the client interface shown in
command:
open 192.168.1.45
b. Enter username client002 and password aabbcc as prompted to log in to the SFTP server.
Figure 58 SFTP client interface
Publickey authentication enabled SFTP client configuration
example
Network requirements
As shown in
assigned the user role network-admin to execute file management and transfer operations. Switch B acts
as the SFTP server and uses publickey authentication and the RSA public key algorithm.
Figure 59 Network diagram
Configuration procedure
In the server configuration, the client's host public key is required. Use the client software to generate the
RSA key pairs on the client before configuring the SFTP server.
Figure 59, you can log in to Switch B through the SFTP client that runs on Switch A and are
Figure
191
58, and enter the following