Configuring Fips Mode; Entering Fips Mode - H3C S5830V2 Security Configuration Manual

save.
Other commands used for configuration preparation to enter FIPS mode.
To switch to non-FIPS mode, execute the undo fips mode enable command in system view, save the
•
configuration, and reboot the device.
Configuration rollback is supported in FIPS mode and also during a switch between FIPS mode and
•
non-FIPS mode. After a configuration rollback between FIPS mode and non-FIPS mode, perform the
following tasks:
d. Delete the local user and configure a new local user. Local user attributes include password,
user role, and service type.
e. Save the current configuration file.
f. Specify the current configuration file as the startup configuration file.
g. Reboot the device. The new configuration takes effect after the reboot. During this process, do
not exit the system or perform other operations.
If a device enters FIPS mode through manual reboot, the startup configuration file does not support
•
configuration rollback. To support configuration rollback, you must execute the save command
before making other configurations.
• Do not use FIPS and non-FIPS devices to create an IRF fabric.
To enable FIPS mode for an IRF fabric, you must reboot the entire IRF fabric.
•

Configuring FIPS mode

Entering FIPS mode

After you enable FIPS mode and reboot the switch, the switch operates in FIPS mode. The FIPS switch has
strict security requirements, and performs self-tests on cryptography modules to verify that they are
operating correctly.
A FIPS device meets the requirements defined in Network Device Protection Profile (NDPP) of Common
Criteria (CC).
The system provides two methods to enter FIPS mode: automatic reboot and manual reboot.
Automatic reboot
To use automatic reboot to enter FIPS mode:
1. Enable FIPS mode.
2. Select the automatic reboot method.
The system automatically performs the following tasks:
a. Create a default FIPS configuration file named fips-startup.cfg.
b. Specify this file as the startup configuration file.
c. Prompt you to configure the username and password for next login.
You can press Ctrl+C to exit the configuration process. The fips mode enable command will not be
executed.
3. Configure a username and password to log in to the device in FIPS mode.
The password must include at least 15 characters that contain uppercase and lowercase letters,
digits, and special characters.
233