The Configuration For A Wlan Connection; Setting The Parameters For A Wireless Network; Selecting And Connecting A Wlan By Hand; Searching For And Selecting The Network - T+A MP 2500 R User Manual

The Configuration for a WLAN connection

Setting the parameters for a
wireless network

Selecting and connecting a WLAN by hand

Searching for and Selecting
the Network
Entering the Password (for
encoded networks)
Storing Network Settings
and Restarting
54
 Check that there is no cable connected to the LAN socket of the MP 2500 R.
 Switch the MP 2500 R on, open the System Configuration menu by pressing
the  button on the remote control handset or the  button on the
front panel of the MP 2500 R.
 Use the  /  buttons to select the menu point "Network", then
confirm your choice with the  button.
The following menu now opens:

First select the menu point "Scan for WLANS", and activate it by
pressing the  button.

A list of the WLANs found is displayed on the screen.

Use the  /  buttons to select the WLAN to which you
wish the MP 2500 R to be connected, and confirm your choice with the
 button.
If the network is encoded, the window shown below will appear once the WLAN
is selected.

At this point please enter the network passphrase and confirm your
input by pressing .

Select the "Store and exit?" point, and confirm your choice with
.
Finally select the "Store and exit?" menu point and press the  button to
accept the settings.

If a WEP code is used, the password must be entered as a hexadecimal code
(0 - 9, A - F).
Possible entries